B0140
Passenger Seatbelt Tension Sensor Circuit
Neither the J2012 code lists available here nor any carmaker's public material contains B0140; its wording repeats B0061, the J2012 code for the front passenger belt tension sensor, and resembles B0182. The part itself is well described. In Delphi's design (US6554318B2) the webbing runs through a slider that moves against springs, while a Hall element between two magnets reads the travel. A second Delphi patent (US6605877B1) sends the tension value over a two-wire line to the module that classifies the occupant, which uses it to tell a tightly strapped child seat from an adult. FMVSS 208 allows automatic passenger airbag suppression for small occupants. A fault in this circuit usually lights the airbag lamp.
Possible causes
- Loose or corroded plug at the passenger belt tension sensor high
- Sensor signal out of range, for example from a jammed slider medium
- Sensor lead trapped under the seat or at the sill panel medium
Symptoms
- Airbag warning lamp on
- Passenger airbag status indicator may show an unexpected state
- Safety note: the sensor sits near pretensioner and side airbag plugs; unplug only with the battery disconnected and the wait time observed
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for B0140
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.