B011B
Camera Washer Actuator S
B011B closes the row with actuator S. Electrically, each actuator in the row is a coil or motor switched by a module or a relay. HELLA's relay guide explains the switching side: a control coil on terminals 85 and 86 pulls in the armature and moves the contact from 87a over to 87, and some types carry a resistor or diode across the coil to tame the spike at switch-off. Asmo's US20120266926A1 energises its camera wash valve through a relay fed from the reversing-lamp circuit, so a fault there can disable the wash as well. An open coil, a sticking relay or a broken feed on this last actuator is what B011B points to. No public source ties S to a particular camera or reports B011B from a real vehicle.
Possible causes
- Coil or motor of actuator S open or shorted high
- Relay feeding actuator S sticking or with a burnt contact medium
- Blown fuse or broken supply wire to the relay or actuator low
Symptoms
- Camera wash for the camera served by actuator S does nothing
- Wash may run continuously or not stop if a relay contact has welded
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for B011B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.