B010E
Camera Washer Actuator E
B010E names actuator E, which may be a dedicated pump rather than a valve. Audi's TSB 2073568/1 (2024) for e-tron, e-tron S and Q8/SQ8 e-tron models reports rear camera washer pressure too low to clean the lens: the mono pump could not build enough pressure, and production moved to a dual pump (1K6 955 651) whose spare outlet is plugged. Before swapping it, technicians rule out low fluid, a clogged pump filter, low supply voltage and kinked lines. AUMOVIO lists its washer pumps with one or two outlets for 2.0 to 4.0 bar. A pump drawing no current or too much is the kind of fault a module can flag; whether any maker calls that pump E is not published, and no manufacturer documents B010E.
Possible causes
- Camera washer pump motor E worn, seized or open high
- Low supply voltage or poor ground at the pump medium
- Clogged inlet filter making the pump labour and draw high current low
Symptoms
- Camera nozzle only dribbles; the spray does not reach across the lens
- Pump hum without spray, or no pump sound at all when the wash is requested
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for B010E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.