B0109
LIDAR Washer Actuator D
B0109 ends the lidar washer group with actuator D; the next codes, B010A onward, move on to camera washers. Four lidar circuits match fleets built for driverless service: Kautex fits two complete Allegro cleaning and clearing systems to every Zoox robotaxi, combining water and air for cameras and lidars. On Ford’s self-driving test cars, nozzles next to each lens spray washer fluid on demand, and the roof tiara that carries cameras and lidar adds an air curtain. In Ford's US10569746B2 the computer can even leave autonomous mode while a lidar window is too opaque. Nothing public tells which unit is D, and no carmaker documents B0109. A failed actuator D usually shows as one lidar staying dirty while the others clean normally.
Possible causes
- Pump or valve D for the fourth lidar nozzle defective high
- Hose to lidar D kinked or pulled off, so the actuator runs dry or overloaded medium
- Open or shorted wire to actuator D low
Symptoms
- One lidar remains dirty while the other sensors are cleaned
- Vehicle limits or ends automated driving
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for B0109
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.