B0101
Sensor Cleaning Air Blower Actuator B
B0101 reports a fault of the second cleaning air source, blower B. A second unit makes sense where sensors are spread over the body: a roof pod and a bumper or corner sensor need separate air supplies. Not every design uses a fan; Uber's 2016 patent (now Aurora) feeds lidar and camera air knives from a compressor and accumulator held at about 140–160 psi, with one solenoid valve per outlet and a pressure sensor that raises a warning on a leak. AUMOVIO's lidar nozzles use compressed air to strip water droplets and to clear dust without washer fluid, and Kautex's Allegro systems combine water and air for camera and lidar. The split between A and B is not published by any carmaker, nor is B0101 itself.
Possible causes
- Blower or compressor B worn out or drawing too much current high
- Leaking or split air hose so blower B cannot build pressure medium
- Water or salt ingress into blower B at an exposed mounting point low
Symptoms
- Cleaning fault shown for the sensor group served by blower B
- Water droplets or dust remain on lidar or camera window
- Assistance functions reduced when the affected sensor goes blind
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for B0101
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.