OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B00C3

Passenger Seat Occupant Classification Sensor D

B00C3 is the fourth passenger seat classification input. No carmaker documents it under this number. Some classification signals are not a weight at all but a frequency, which makes them prone to electrical noise. Tesla reported for 2017–2019 Model 3 cars that the OCS frequency could leave its valid range because of interference on the passenger seat harness, so the airbag symbol appeared on the touchscreen. The first fix added a harness extension with a ferrite filter at the OCS module, which sits under the front of the seat; a later bulletin used a dedicated filter module, each about 0.15 h of labour. Whether a maker files such a signal as D is not known. A stored B00C3 means this input is missing or out of range, and the airbag lamp stays on until the cause is found.

SystemBody
Typegeneric / SAE
GroupB0
Range / number– / C3

Possible causes

  • Electrical interference coupled into the seat harness (seat heating, motors, routing near other leads) medium
  • Harness under tension or plug loose at the classification module when the seat moves medium
  • Internal fault of sensor D or the classification module low

Symptoms

  • Airbag warning lamp or airbag symbol on the display
  • Fault may depend on seat position or on other electrical loads being switched on
  • Safety note: occupant classification unreliable; work on seat wiring only de-energised (12 V off, wait time), use the maker's filter or rework kit where one exists, specialist workshop only

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for B00C3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication