B00BB
Driver Seat Occupant Position Sensor E
B00BB is the fifth and last driver seat occupant position sensor in the J2012 block. No carmaker publishes this code. Position need not be measured on the body itself: an ATI patent family dating back to 1992 infers it from the seat, using a potentiometer or other track sensor, a recline angle sensor and belt spool-out from a shaft encoder in the retractor, and may suppress or depower the bag when the seat is fully forward. FMVSS 208 leaves both the suppression zone and the choice of sensors to the maker. Because J2012 already has separate codes for the indirect seat data, B00B5 for the track and B00B6 for the recline, the letter E probably denotes a further direct sensor, though no source confirms it. When B00BB is stored, the airbag lamp is lit.
Possible causes
- Open, shorted or loose lead to position sensor E high
- Restraint module configured for a fifth position sensor that is not fitted medium
- Internal fault of position sensor E low
Symptoms
- Airbag warning lamp on
- Position-based adjustment of the driver airbag partly unavailable
- Safety note: airbag system; disconnect sensor and seat plugs only de-energised (ignition off, battery off, wait time); calibrate the sensor after replacement, specialist workshop only
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for B00BB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.