B00B6
Driver Seat Recline Position Restraints Sensor
B00B6 concerns a sensor that tells the restraint system how far the backrest of the driver seat is reclined. No carmaker documents this code publicly, and the NHTSA bulletin index has no entry for it. Patents show why the angle matters: an ATI patent lets the controller suppress or depower the airbag from seat position, back angle and belt spool-out alone, without looking at the occupant, and a Bosch application derives the tilt from a three-axis accelerometer in the seat back, uses a 45 degree limit to decide which airbags fire and feeds the angle into occupant classification. Autoliv even calibrated its classification mat at several back angles. If B00B6 is stored the module loses that input; the airbag lamp stays on until the sensor or its circuit is repaired.
Possible causes
- Lead pinched or broken at the seat back hinge, where it flexes with every adjustment high
- Internal fault or loose mounting of the recline sensor medium
- Sensor or seat back replaced without the required zero setting low
Symptoms
- Airbag warning lamp on
- Airbag adaptation to a reclined seating position unavailable
- Safety note: airbag system; disconnect seat and sensor plugs only de-energised (ignition off, battery off, wait time); calibrate the sensor after replacement, specialist workshop only
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for B00B6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.