OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B00A0

Occupant Classification System

B00A0 is the catch-all code for occupant classification, the function that judges at the front passenger place whether the passenger airbag may fire and with what force, as FMVSS 208 demands for advanced airbags. Mitsubishi lists it as OCCUPANT SENS UNIT with ten subtypes, among them sensor faults (-02/-09), low supply or unfinished zero-point reset (-22, battery at 9 V or less), lost communication (-83/-86/-87/-88) and a reset error (-93); most are set after 2 s with the ignition on, -88 after 5 s and -87 after 10 s. Mazda traced B00A0:09 on the CX-3 and CX-5 to a sensor too quick to react to low voltage while cranking and replaces the cushion (08-002/23). Nissan reprograms the OCS unit when zero reset fails (NTB19-071D). The airbag lamp lights.

SystemBody
Typegeneric / SAE
GroupB0
Range / number– / A0

Possible causes

  • Poor contact or open circuit in the passenger seat harness or plug, often after seat removal high
  • Low battery voltage or voltage dip while cranking (Mitsubishi -22, Mazda B00A0:09) medium
  • Zero-point reset not done or not possible after seat work (Nissan reprograms the unit) medium
  • Internal fault of the classification sensor or control unit, often replaced with the seat cushion medium

Symptoms

  • Airbag warning lamp on
  • Passenger airbag status lamp shows the wrong state or the passenger airbag stays switched off
  • Fault may appear only after cold starts with a weak battery
  • Safety note: airbag system; unplug seat and sensor connectors only de-energised; after replacing seat sensors or the unit, the zero-point reset/calibration must be done, specialist workshop only

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for B00A0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication