OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B009F

Right Side Restraints Sensor 6

B009F would be the sixth and last right-hand restraints sensor in the J2012 block. No carmaker documents it publicly with this meaning. The number does appear at GM, but for another part: on 2008–2013 two-mode hybrid Tahoe, Yukon, Escalade, Silverado and Sierra trucks, bulletin PIT4614C ties a no-crank condition with B009F stored in the SDGM gateway to water passing the seal of the HVCID crash sensor for the high-voltage circuit, mounted on the lower radiator support; the sensor and terminals are inspected and replaced. That is a crash switch for isolating the hybrid battery, not an airbag satellite. A genuine sixth right satellite would be an acceleration unit, for example a PSI5-linked Bosch SMA773 sensor on a rear pillar or sill. Its failure lights the airbag lamp.

SystemBody
Typegeneric / SAE
GroupB0
Range / number– / 9F

Possible causes

  • Damaged rear body harness or plug to the sixth right sensor high
  • Internal fault of the sixth right acceleration satellite medium
  • On GM two-mode hybrids, water or corrosion at the high-voltage impact detection sensor (different meaning, PIT4614C) low

Symptoms

  • Airbag warning lamp on
  • On GM two-mode hybrids, no crank or a Service Hybrid message instead
  • Safety note: airbag and, on hybrids, high-voltage system; disconnect plugs only de-energised; after a sensor change have it checked or initialised, specialist workshop only

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for B009F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication