OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B0099

Roll Over Sensor

B0099 reports a fault in the rollover sensing that decides whether curtain airbags and pretensioners fire when a vehicle tips. Bosch integrates rollover sensors in its base airbag control unit, so the sensor is often part of the module. A Delphi patent shows the principle: roll rate and low-g vertical acceleration give roll angle and rate, which are compared with deploy and no-deploy curves, while a high-g lateral accelerometer acts as a separate arming check. FMVSS 226 requires a monitored readiness indicator where ejection mitigation deploys in a rollover; Karma recalled the 2018 Revero because its rollover sensing was not enabled. FCA uses the code: recall Y79 (2021 Grand Cherokee, 2022 Wagoneer) has technicians check for B0099-96 before reflashing the restraint controller, without defining it. The airbag lamp lights.

SystemBody
Typegeneric / SAE
GroupB0
Range / number– / 99

Possible causes

  • Internal fault of the rollover sensor built into the airbag control unit (module replacement) high
  • Airbag unit loose, mounted at an angle or after a crash no longer within its fitting tolerance medium
  • Wiring or plug fault where a separate rollover sensor is fitted low
  • Restraint controller software or configuration not matching the vehicle low

Symptoms

  • Airbag warning lamp on
  • Curtain airbags and pretensioners may not fire in a rollover
  • Safety note: airbag control unit with rollover sensing; work only de-energised (battery off, wait time) at a specialist workshop

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for B0099

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication