OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B0098

Right Side Restraints Sensor 3

B0098 belongs to the third right-side crash sensor. In Mitsubishi's airbag index it is the C-PILLAR SAT SEN RH, given with the J2012 wording Right Side Restraints Sensor 3. The full set of nine subtypes applies, each set two seconds after detection with the ignition on; beside the usual short to ground (-11), configuration mismatch (-55) and lost communication (-81), the list covers a short to supply (-12), an open line (-88), an offset error (-28) and a reset fault (-93). A sensor this far back sees impacts on the rear door and rear seat area early. Continental's gSAT reports acceleration from rigid structure for such tasks. FCA uses its own code B2765 for the right C-pillar sensor of the Ram 1500, while the Saab 9-3 airbag module uses B0098 to flag that its passenger presence system has failed in general. The airbag lamp lights.

SystemBody
Typegeneric / SAE
GroupB0
Range / number– / 98

Possible causes

  • Open or shorted line or poor contact at the right C-pillar plug (subtypes -11/-12/-88/-81) high
  • Internal fault of the right C-pillar sensor, e.g. offset or reset error (subtypes -28/-93) medium
  • Airbag unit configuration not matching the vehicle (subtype -55) low
  • On the Saab 9-3, passenger presence system fault (different meaning) low

Symptoms

  • Airbag warning lamp on
  • Right side impact sensing at the rear door is degraded
  • Safety note: airbag system; disconnect the battery and keep the wait time before work at the rear pillar, specialist workshop only

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for B0098

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication