OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B0094

Center Frontal Restraints Sensor

B0094 refers to a single crash sensor placed in the middle of the vehicle front, used where a car has one central frontal satellite rather than a left and right pair. Mitsubishi's airbag unit shows it as CRASH ZONE SENS and adds the J2012 name Center Frontal Restraints Sensor. Its index lists nine subtypes, logged once a fault has persisted for two seconds at ignition on: -11 and -12 for shorts to ground or supply, -88 for an open line, -81 for lost communication, -25 for a failed self-diagnosis, -28 for an offset error, -93 for a reset fault, -55 for a configuration mismatch and -86 when sensor and unit are not the specified parts. That index has no B0090 or B0095, so the centre unit is the only frontal satellite there. Bosch notes that crumple-zone acceleration sensors improve frontal crash detection. The airbag lamp lights.

SystemBody
Typegeneric / SAE
GroupB0
Range / number– / 94

Possible causes

  • Open, short or corroded contact in the harness to the centre front sensor (subtypes -11/-12/-88) high
  • Internal fault of the crash zone sensor, e.g. offset or self-diagnosis error (subtypes -25/-28) medium
  • Sensor or airbag unit not the specified part, or unit configuration wrong (subtypes -86/-55) medium
  • Sensor or bracket bent by a front-end impact or refitted poorly after body work low

Symptoms

  • Airbag warning lamp on
  • Frontal crash detection falls back on the sensors inside the airbag unit
  • Safety note: airbag system; disconnect the battery and keep the wait time before work at the front sensor, specialist workshop only

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for B0094

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication