OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B0093

Left Side Restraints Sensor 3

B0093 is the third left-side crash sensor. Mitsubishi mounts it at the left C-pillar, names it C-PILLAR SAT SEN LH and gives the J2012 wording Left Side Restraints Sensor 3. Unlike the B-pillar unit, it carries the full set of subtypes: -11 when the sensor line is shorted to ground, -55 for a configuration mismatch, -81 when communication with the sensor fails, and others, each confirmed after two seconds with the ignition on. A sensor that far back can give the module an early view of impacts behind the front door. Bosch lists C-pillars among the mounting points for its acceleration satellites, and Continental's gSAT measures acceleration in rigid structure for the same purpose. The airbag lamp lights while B0093 is stored.

SystemBody
Typegeneric / SAE
GroupB0
Range / number– / 93

Possible causes

  • Sensor line shorted to ground or poor contact at the C-pillar plug (subtypes -11/-81) high
  • Internal fault of the C-pillar satellite sensor medium
  • Airbag unit configuration not matching the vehicle (subtype -55) medium
  • Internal fault of the airbag diagnosis unit low

Symptoms

  • Airbag warning lamp on
  • Left side impact sensing behind the front door is degraded
  • Safety note: airbag system; disconnect the battery and keep the wait time before work at the rear pillar, specialist workshop only

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for B0093

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication