OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B0091

Left Side Restraints Sensor 1

B0091 covers the first left-side crash sensor, which Mitsubishi places in the front door and lists as DOOR SATEL SENS LH with the J2012 title in brackets. The airbag unit checks it with the ignition on and stores a subtype after a two-second delay: -11 for a short to ground, -55 when the configuration held in the unit does not fit the vehicle, -81 for a communication fault, plus further bytes. Door satellites of this kind are usually pressure sensors: Bosch explains that the sealed door cavity acts as the sensing volume, so a crush raises pressure and the module can decide within about 5 ms. Continental sells a pressure satellite for the same task. With B0091 set, the airbag lamp lights and left side impact sensing may be weakened.

SystemBody
Typegeneric / SAE
GroupB0
Range / number– / 91

Possible causes

  • Short or poor contact in the door harness or connector to the sensor high
  • Internal fault of the front door satellite sensor medium
  • Airbag unit configuration not matching the vehicle (Mitsubishi subtype -55) medium
  • Internal fault of the airbag diagnosis unit low

Symptoms

  • Airbag warning lamp on
  • Side and curtain airbags on the left may deploy late or not in a side impact
  • Safety note: airbag system; disconnect the battery and keep the wait time before door work, then have it checked at a specialist workshop

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for B0091

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication