OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B0090

Left Frontal Restraints Sensor

B0090 concerns the left frontal crash sensor, a satellite accelerometer in the front crumple zone that tells the airbag module early how hard the front end is being hit. Bosch notes such upfront units sharpen frontal crash detection beside the central sensors. Several makers use the code exactly so. Acura bulletin 18-016 (2017 ILX) describes B0090-87, a missing signal of the left frontal impact sensor, caused by water entering the connector through a wire size variance; sensor and engine bay harness are replaced. For the Ram 1500, FCA reports B0090-49, internal electronic failure of the left frontal acceleration sensor: after sensor replacement the part number must match the restraint controller (STAR S2408000050), and TSB 08-150-26 (2025 Ram 1500) reflashes the controller. The airbag lamp comes on.

SystemBody
Typegeneric / SAE
GroupB0
Range / number– / 90

Possible causes

  • Water in the left front sensor connector damaging the harness (Acura 18-016) high
  • Replacement sensor part number not matching the restraint controller (FCA S2408000050) medium
  • Restraint controller software needing a reflash (FCA TSB 08-150-26) medium
  • Sensor damaged by a front-end impact or poor refitting after body repair low

Symptoms

  • Airbag warning lamp on, often after front-end repair or water exposure
  • Frontal crash detection relies on the module's internal sensor only
  • Safety note: airbag system; disconnect the battery and observe the wait time before touching sensors or wiring, work at a specialist workshop

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for B0090

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication