OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B007E

Driver Seat Belt Pretensioner C Deployment Control

B007E is the driver's third (C) pretensioner circuit. Mercedes-Benz fills this slot with the retractor: in LI54.21-P-070658 for the A-, CLA- and GLB-Class, B007E13 is an open circuit at the squib of the driver's emergency tensioning retractor, with B0079 for the belt end fitting tensioner and B0080 for the driver's belt force limiter. The retractor unit is housed either inside the B-pillar or within the seat and winds the spool back to remove slack from the shoulder belt, as GM and Joyson explain. The same Mercedes list puts the rear retractors on the C codes B00E3, B00E4, B00E6 and B00E7, so there the C stage consistently means the retractor. A stored B007E means the airbag lamp is on and the driver's shoulder belt will not be pretensioned.

SystemBody
Typegeneric / SAE
GroupB0
Range / number– / 7E

Possible causes

  • Retractor plug at the lower driver-side B-pillar loose or terminals spread high
  • Harness pinched by B-pillar or sill trim medium
  • Internal fault of the driver retractor pretensioner low

Symptoms

  • Airbag warning lamp on
  • Driver's shoulder belt is not tightened in a crash
  • Safety note: the retractor holds a pyrotechnic charge; disconnect the battery, wait, and leave the work to a specialist workshop

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for B007E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication