OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B007C

Second Row Right Seat Belt Pretensioner B Deployment Control

B007C is the second-row right counterpart of B007B: an additional pretensioner stage at the right outer rear seat. No manufacturer publishes this code. On that seat Mitsubishi uses B0075 for its retractor pretensioner and Mercedes uses B00E4 for the right rear emergency tensioning retractor, so neither leaves a role for B007C. A B stage would typically be a buckle or anchor unit acting on the lap belt; NHTSA's 2013 evaluation explains how a buckle pretensioner pulls the buckle down by a cable and piston, while Joyson describes lap tensioners working with the retractor. Rear lap units are far less common than front ones, so this code is unusual. When it does appear, the airbag lamp stays on and that stage cannot be counted on.

SystemBody
Typegeneric / SAE
GroupB0
Range / number– / 7C

Possible causes

  • Plug of the right rear buckle or anchor tensioner loosened during seat work high
  • Airbag module configuration lists a stage that is not installed medium
  • Internal fault of the right rear B-stage tensioner low

Symptoms

  • Airbag warning lamp on
  • Right rear lap belt not pretensioned in a crash
  • Safety note: the tensioner contains a pyrotechnic charge; only work on it with the battery disconnected and at a specialist workshop

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for B007C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication