OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B0064

Driver Seat Belt Pretensioner Deployment Loop Resistance Low

No publicly available J2012 code list includes B0064; there, B0060 names the driver belt tension sensor. Older airbag modules from General Motors do use it: on the 2006 Saab 9-5, B0064 is set when the resistance of the driver pretensioner loop stays below 1.5 ohms, with a 0.2-ohm tolerance, for 2 seconds; B0065 marks an interrupted loop and B0066 a voltage at pin 34 outside 1.0 to 4.1 V. Saab 9-3 manuals of 2003 and 2007 describe the same fault as too little resistance at the driver's belt tensioner. The module still attempts to fire the pretensioner in a crash. GM bulletin 14609 names B0064 among the codes caused by fatigue breaks in the rear door harness of Colorado and Canyon extended cab trucks, model years 2004 to 2009. Airbag lamp on.

SystemBody
Typegeneric / SAE
GroupB0
Range / number– / 64

Possible causes

  • Pretensioner leads shorted together, e.g. squashed harness at the B-pillar high
  • Colorado/Canyon extended cab: fatigued wires in the rear door harness (bulletin 14609) medium
  • Damaged or contaminated pretensioner connector medium
  • Internal fault of the driver pretensioner squib low

Symptoms

  • Airbag warning lamp on
  • Driver belt pretensioner may not work properly in a crash
  • Safety note: pretensioner plugs sit at the B-pillar or under the seat; do not probe the loop and only unplug them with the battery disconnected and the wait time observed

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for B0064

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication