OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B0058

Third Row Right Seat Belt Sensor

B0058 is the J2012 code for the buckle sensor at the right seat of the third row. The sensor reports a latched or free belt to the module that runs the rear belt display, which FMVSS 208 S7.5(c) makes mandatory for every rear seat from September 2028. Fold-flat third rows and access from the right-hand sliding door put the lead under strain. No carmaker documents B0058 publicly with this meaning. Older GM modules again differ: on the 2006 Saab 9-5 B0058 means an open passenger pretensioner loop, with more than 4.5 ± 0.2 ohms for 2 seconds, while the Saab 9-3 also knows a high-resistance variant. GM bulletin 14609 for 2004-09 Colorado and Canyon extended cabs covers B0058 among the pretensioner codes caused by broken rear door wires.

SystemBody
Typegeneric / SAE
GroupB0
Range / number– / 58

Possible causes

  • Buckle lead of the right third-row seat damaged by folding or loading medium
  • Older GM/Saab module: open passenger pretensioner loop, e.g. broken rear door wire medium
  • Faulty sensor in the right third-row buckle low

Symptoms

  • Airbag warning lamp on
  • Depending on the module: right third-row seat shown wrongly, or passenger pretensioner may not fire
  • Safety note: buckle and pretensioner plugs carry firing circuits nearby; only unplug them with the battery disconnected and the wait time observed

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for B0058

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication