OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B0055

Second Row Right Seat Belt Sensor

B0055 stands for the buckle sensor of the right seat in the second row, behind the front passenger and in vans often beside the sliding door. Where that seat is a removable captain's chair, a disconnect in the buckle lead is unavoidable; IEE points out in a patent that a wireless buckle sensor alone cannot tell the module whether the seat is fitted, so a missing signal may mean a fault or simply an empty floor. A seat refitted with its plug left open is therefore a common trigger. CTS supplies non-contact Hall buckle switches for such uses. The rear belt warning of FMVSS 208, section S7.5(c), applies to this seat for vehicles made after 1 September 2028. No carmaker documents B0055 publicly; the Mitsubishi passenger code B0052 is the nearest documented model.

SystemBody
Typegeneric / SAE
GroupB0
Range / number– / 55

Possible causes

  • Seat connector not engaged after the removable seat was refitted high
  • Corroded buckle connector, e.g. from wet floor near the sliding door medium
  • Faulty sensor in the right rear buckle medium

Symptoms

  • Airbag or rear belt warning lamp on
  • Right rear seat shown wrongly or missing in the belt status display
  • Safety note: seat and buckle plugs under the seat lie near pretensioner and side airbag lines; only unplug them with the battery disconnected and the wait time observed

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for B0055

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication