OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B0053

Second Row Left Seat Belt Sensor

B0053 is the J2012 slot for the buckle sensor at the second row's left seat. Rear buckle sensors drive the rear belt reminder: for vehicles built from September 2028, FMVSS 208 S7.5(c) demands a start-up display of which rear belts are fastened or open and a warning when one is unlatched while driving. No carmaker documents B0053 with this meaning publicly; the closest documented case is Mitsubishi's passenger code B0052, set for an open, shorted or invalid buckle signal lasting 2 seconds. Older GM airbag modules give the number another meaning: the Saab 9-3 and the 2006 Saab 9-5 store B0053 when a deployment was commanded while a firing loop fault was present, a code that cannot be erased after a front airbag deployment.

SystemBody
Typegeneric / SAE
GroupB0
Range / number– / 53

Possible causes

  • Loose or corroded buckle connector under the left rear seat high
  • Faulty switch or Hall sensor in the left rear buckle medium
  • Lead damaged by folding or sliding the second-row seat medium
  • Older GM/Saab module: deployment record with a loop fault, module replacement needed low

Symptoms

  • Airbag or rear belt warning lamp on
  • Rear belt display shows the left seat wrongly as fastened or unfastened
  • Safety note: the buckle plug sits under the seat near pretensioner and side airbag plugs; only unplug it with the battery disconnected and the wait time observed

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for B0053

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication