OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B0026

Left Side Deployment Stage 2 Loop Open

B0026 is missing from the public J2012 lists. General Motors documents it in older restraint modules with a meaning other than the title: on the 2006 Saab 9-5, B0026 is an open circuit in driver frontal stage 1, set when the measured resistance stays above 4.5 ohms, tolerance 0.2, for 2 seconds; the Saab 9-3 manuals add bytes for an open loop and too high resistance in the same driver circuit. GM bulletin 08-09-41-002H blames loose connector position locks for B0026 on 2005-14 models such as the Cobalt, Pontiac G5 and GMC Envoy. An open second stage of a left side airbag is not publicly documented under this code. If the driver loop is open, the steering wheel airbag may not fire. Airbag lamp on.

SystemBody
Typegeneric / SAE
GroupB0
Range / number– / 26

Possible causes

  • Airbag connector or its position lock not fully seated (GM 08-09-41-002H) high
  • Broken track in the clock spring (driver loop on older GM/Saab) medium
  • Open squib inside the airbag module low

Symptoms

  • Airbag warning lamp on
  • Depending on the vehicle, the driver airbag may not deploy
  • Safety note: do not probe the airbag circuit yourself; unplug airbag connectors only with the battery disconnected and the stated wait time observed

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for B0026

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication