OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B0019

Center Frontal Stage 2 Deployment Control

B0019 is the stage 2 member of the first-row center frontal series B0018 to B001A, meant for the second inflator charge of a middle-seat frontal airbag. No carmaker publicly documents the code with this meaning. General Motors uses B0019 widely, but for stage 1 of the passenger airbag in the instrument panel: on the Saab 9-4X 2011 sub-codes 01 and 02 mark shorts, 04 an open, 0D a loop reading that stays high and 0E one that stays low, while stage 2 of that bag is B0020. On the 2009-10 Chevrolet HHR, fretting corrosion in the in-line connector between body and dash harness raised loop resistance and set B0019 0D or 04 (PI0117B and a customer satisfaction program). On GM vehicles the passenger airbag therefore needs checking first. The airbag lamp is on.

SystemBody
Typegeneric / SAE
GroupB0
Range / number– / 19

Possible causes

  • On GM vehicles fretting corrosion in the passenger airbag in-line connector (HHR PI0117B) high
  • Fault in the stage 2 loop of a first-row center frontal airbag (J2012 meaning) low
  • Internal fault in the airbag module on this loop low

Symptoms

  • Airbag warning lamp on
  • On GM the passenger frontal airbag stage 1 may not deploy
  • Safety note: do not probe the airbag circuit yourself; unplug airbag connectors only with the battery disconnected and the stated wait time observed

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for B0019

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication