OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B0018

Center Frontal Stage 1 Deployment Control

In the J2012 order of seating positions (driver, passenger, center, then second and third row) B0018 covers stage 1 of a frontal airbag for the middle seat of the first row. FMVSS 208 demands frontal airbags only for the outboard front seats, so such a bag is rare, and no carmaker publicly documents B0018 with this meaning. It is not the GM front center airbag of 2013, which deploys from the inner flank of the driver seat in side impacts (SAE 2013-01-1156). GM did use B0018 itself in older modules: on the Saab 9-5 2006 it reports a voltage out of range in the passenger frontal stage 1 circuit, above 4.1 V or below 1.0 V at module pin 44 for two seconds, and on the Saab 9-3 a short to battery or ground in that loop. Check which module stored the code.

SystemBody
Typegeneric / SAE
GroupB0
Range / number– / 18

Possible causes

  • Open or shorted stage 1 loop of a first-row center frontal airbag (J2012 meaning) medium
  • On older GM/Saab passenger frontal stage 1 loop shorted to battery or ground medium
  • Restraint control module fault low

Symptoms

  • Airbag warning lamp on
  • Affected frontal airbag stage may not deploy
  • Safety note: do not probe the airbag circuit yourself; unplug airbag connectors only with the battery disconnected and the stated wait time observed

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for B0018

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication