B0016
Right Front/Passenger Frontal Deployment Loop Short to Ground
The public J2012 code lists skip B0016. General Motors used it in two generations with different meanings. In older modules, documented for the Saab 9-5 2006 and the Saab 9-3 up to 2011, B0016 means low resistance in the passenger frontal stage 1 loop: the reading drops under about 1.5 ohms, tolerance 0.2, for two seconds. That is close to the title, since a short to ground or between the leads also pulls the measured resistance down. In later GM modules (Saab 9-4X 2011) B0016 is the left roof rail airbag loop, with its own bytes for short to ground (02) and low resistance below 1.4 ohms (0E). GM bulletin 08-09-41-002H lists B0016 among codes caused by unseated connector locks on many 2005-14 GM models. The airbag lamp is on in every case.
Possible causes
- Squib leads shorted together or to ground in the passenger frontal loop (older GM) high
- Connector position assurance lock not seated (GM 08-09-41-002H) medium
- On later GM vehicles fault in the left roof rail airbag loop medium
Symptoms
- Airbag warning lamp on
- Passenger frontal airbag stage 1 (older GM) or left head airbag (later GM) may not deploy
- Safety note: do not probe the airbag circuit yourself; unplug airbag connectors only with the battery disconnected and the stated wait time observed
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for B0016
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.