B0015
Passenger Knee Airbag Deployment Control
B0015 does not appear in the public J2012 code lists, which assign the passenger knee airbag to B0013. Only General Motors documents the number, as the firing loop of the belt pretensioner built into the driver's retractor. In the Saab 9-4X 2011 manual this pretensioner shares one diagnostic page with B001A, the anchor pretensioner, and both trip when their loop stays outside the allowed resistance band or touches supply or ground for two seconds. On the 2009-11 Impala GM notes that B0015 points to the retractor pretensioner while a second pretensioner sits at the belt anchor (PIC5396A). On an Equinox, a wire under the power seat rubbing on the seat motor set B0014 and B0015 and blew the seat fuse (PIT4898C). A passenger knee airbag under this number is not publicly documented. The airbag lamp is on.
Possible causes
- On GM vehicles loose or corroded connector at the driver belt pretensioner high
- Harness under the power seat rubbing on frame or seat motor (GM PIT4898C) medium
- Internal fault in the pretensioner or airbag served by this loop low
Symptoms
- Airbag warning lamp on, sometimes intermittent
- On GM, belt pretensioner may not fire; power seat may fail if the harness is shorted
- Safety note: do not probe the airbag circuit yourself; unplug airbag connectors only with the battery disconnected and the stated wait time observed
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for B0015
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.