OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B0014

Driver Knee Airbag Deployment Control

B0014 is not in the public J2012 code lists; there the driver knee airbag has B0004 and the passenger knee airbag B0013. The number is documented only at General Motors, and with another meaning. GM modules from about 2010 use B0014 for the side airbag in the driver seat; the Saab 9-4X 2011 manual adds a fault byte for each failure, from a shorted or open loop to a high reading (0D, over 4.2 ohms) or a low one (0E, under 1.4 ohms). GM bulletins blame chafed or loose seat harness connectors and high connector resistance on Silverado and Tahoe 2014-15, Equinox, Traverse and the Bolt EV. Older Saab 9-3 modules used B0014 for a short in the passenger frontal stage 2 loop. A knee airbag meaning for this code is not publicly documented.

SystemBody
Typegeneric / SAE
GroupB0
Range / number– / 14

Possible causes

  • On GM vehicles loose or high-resistance side airbag connector under or in the driver seat high
  • Seat harness chafed by seat frame, motor or foam medium
  • Internal fault in the airbag module served by this loop low

Symptoms

  • Airbag warning lamp or service airbag message, often intermittent
  • Affected airbag may not deploy
  • Safety note: do not probe the airbag circuit yourself; unplug airbag connectors only with the battery disconnected and the stated wait time observed

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for B0014

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication