OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B0012

Passenger Frontal Stage 3 Deployment Control

In the J2012 order B0012 is the third element of the front passenger airbag. Mercedes-Benz uses B001213 for the squib of the vent valve in that airbag, and Mitsubishi lists B0012 as passenger airbag module 3. GM gives the number a different meaning. Its later sensing and diagnostic modules assign B0012 to stage 1 of the steering wheel airbag; the Saab 9-4X 2011 manual trips it after two seconds of contact with supply or ground, an open, more than 4.4 ohms or less than 1.7 ohms; GM bulletins link it to chafed coil wires on the 2009 Cobalt and to weak terminal tension at the coil connector on the 2015 CTS. Older Saab 9-3 modules used B0012 for low resistance in the passenger stage 2 loop. Read the code with the maker's tool before choosing which airbag to check.

SystemBody
Typegeneric / SAE
GroupB0
Range / number– / 12

Possible causes

  • Open or shorted third squib (vent valve) in the passenger airbag (J2012 meaning) medium
  • On GM vehicles weak terminal tension or chafed wires at the steering wheel airbag coil high
  • Restraint control module fault low

Symptoms

  • Airbag warning lamp on
  • Depending on maker, passenger airbag venting or GM driver airbag stage 1 affected
  • Safety note: do not probe the airbag circuit yourself; unplug airbag connectors only with the battery disconnected and the stated wait time observed

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for B0012

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 5 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication