B0001
Driver Frontal Stage 1 Deployment Control
The restraint control module tests the firing loop of the first inflator stage in the driver airbag, which sits in the steering wheel hub and is fed through the clock spring. B0001 is stored when that loop is open, shorted or outside its resistance window; the fault byte added to the code names the exact type. Mercedes-Benz logs B000113 for an open stage 1 squib, Honda used B0001-13 on the 2013 Civic, Mitsubishi files it under the driver airbag module, FCA under squib 1, and GM on its 2020-21 full-size trucks, where B0001-1B came from rust particles at the airbag connector raising the resistance (bulletin 21-NA-005). Stage 1 is the charge used in every deployment, so a fault here can cost the driver frontal protection. The airbag warning lamp stays lit.
Possible causes
- Corroded or poorly seated connector between steering wheel harness and airbag module high
- Broken or worn conductor in the clock spring medium
- Internal fault in the driver airbag module (stage 1 squib) medium
- Chafed lead in the steering wheel or column harness low
Symptoms
- Airbag warning lamp or service airbag message stays on
- Driver frontal airbag may not deploy in a crash
- Safety note: do not probe the airbag circuit yourself; unplug airbag connectors only with the battery disconnected and the stated wait time observed
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for B0001
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.